active sensor การใช้

• Active sensors had blue connectors and Passive sensors had yellow connectors.
• In regard to sensors, airborne sensor operators work with either active sensors or passive sensors.
• CMOS chips, by contrast, consist of active sensors that have tiny transistors as power sources.
• Sensors are classified into three categories : passive, omnidirectional sensors; passive, narrow-beam sensors; and active sensors.
• The system includes a 3D active sensor, a thermal imager and Neptec's model based tracking software.
• Sensors may be passive or coupled to an active source ( i . e ., " active sensor " ).
• The other application is to serve as a self-powered active sensor, because it does not need an external power source to drive.
• Active sensors actively probe the environment, for example, a sonar or radar sensor, and they require continuous energy from a power source.
• The typical active sensors used by sensor operators are Synthetic Aperture Radar ( SAR ), Light Detection and Ranging ( LIDAR ) and sonar.
• If the player has selected the EMCON option, none of his units start the game with active sensors on; only passive sensors will be engaged.
• For those reasons, the use of PVDF active sensors is a keystone for the development of future structural health monitoring methods, due to their low cost and compliance.
• Here satellites use different sensor packages to passively measure the reflectance from parts of the electromagnetic spectrum or radio waves that were sent out from an active sensor such as radar.
• Because the system passively detects energy in the far infrared ( heat ) wavelengths, it avoids the disadvantages of active sensors, such as night vision or radar, minimizing the amount of detectable energy emitted by the aircraft.
• The sensors are almost exclusively passive, recording what they see, similar to a camera, in contrast to active sensors ( radar, lidar ) that send out a signal and detect its impact on the area being observed.
• First, the active sensor is capable of both static pressure sensing using the open-circuit voltage and dynamic pressure sensing using the short-circuit current, while conventional sensors are usually incapable of dynamic sensing to provide the loading rate information.
• A typical modern nav / attack system is based around an inertial navigation system ( INS ) that allows the aircrew to locate the target area without reliance on active sensors such as radar that might alert enemies to the aircraft's presence.
• Third, the detection limit of the TENG for dynamic sensing is as low as 2.1 Pa, owing to the high output of the TENG . Fourth, the active sensor array presented in this work has no power consumption and could even be combined with its energy harvesting functionality for self-powered pressure mapping.